Fit for Range Rover L322 2002-2012 High Rear Bumper Brake Light XFG000040

These descriptions are close to the actual driving scenarios, highlighting the product's adaptability and durability, and allowing customers to directly feel the benefits after use. Coupled with the comparison pictures before and after installation, it is even easier to arouse buyers' desire to purchase.

1. The Rear High Mount Brake Light fits perfectly with the original vehicle. After installation, it looks just like a new one. It is specially designed for the Land Rover 1. The Rear High Mount Brake Light is an exact match for the original car. When you install it, it looks just like it came from the factory. It's made according to the original data of the Range Rover L322. The curve and size fit perfectly with the tailgate glass. One guy said, “I replaced the brake light on my 2008 Range Rover, and no one could tell it was a replacement. Even the car - wash guy asked if I'd just had the interior redone.” It completely solves the problems of the old lights turning yellow and cracking for Land Rover Range Rover L322 from 2004 - 2012. The rear of the car looks brand - new right away.

2. The RED Rear Third Brake Light Lamp is super bright. Cars behind can see it from a long way off. It uses high - brightness LED beads, which are much brighter than the original bulbs. One driver said, “Last time I had to brake suddenly on the highway, and the car behind started slowing down more than a hundred meters away. Before I changed it, I always got rear - ended.” It has strong penetration on rainy and cloudy days, so the cars behind can react earlier. You'll feel more at ease when driving.

3. The High - Mount Third Brake Light XFG000040 is very durable and can withstand bumps. It doesn't shake even on rough roads. There's a fixing frame inside the lamp body, specially designed to fit the Range Rover's suspension. One off - roader said, “On the dirt roads in the countryside, the old light always had poor contact because of the bumps, but this one stays steady no matter how much it shakes.” It's not affected when going over speed bumps or on unpaved roads. You can go off - road with confidence.

4. The Rear Tail Stop Lamp Stop Lamp Tail Warning Light can handle both hot and cold temperatures, so it can be used in both the north and the south. The shell is made of high - quality materials. It doesn't soften in the summer sun and doesn't crack even at dozens of degrees below zero in winter. One owner in the Northeast said, “I parked my car outside at minus 30 degrees, and the plastic shell of the old light became brittle, but this one has been fine for three years.” It doesn't get moldy during the rainy season in the south, so it can be used all over the country.

Here are three specific application scenarios of car tailgate switch:

1. Just plug it in and it works. You can install it yourself. The plug is exactly the same as the original vehicle's plug. Just align it and plug it in. There's no need to cut the wires. "Follow the instructions to tighten a few screws, and it'll be done in 20 minutes. It saves hundreds of hours of labor costs at the 4S store," After installing the dashboard, there are no errors reported and it doesn't affect other functions of the car.

2. It doesn't accumulate water or fog. It's clear even on rainy days. The inner side of the lamp housing has a fog-proof coating, and there are small drainage holes at the bottom. "Before, the lights were always foggy when it rained. The car behind said they couldn't see clearly. Now, it's bright in any weather. Even if you wash the car vigorously, there's no problem. The brake signal is clearly visible."

3. It saves power and is durable. It doesn't need to be replaced for ten years. LED bulbs consume less power. They use half the electricity of the original car bulbs and can last for a long time. "The original car bulbs need to be replaced once a year. This one has been installed for five years and is still in good condition. It saves a lot of trouble." You don't have to worry about the lights suddenly breaking when you're on long trips or going on a long journey.

Q: What auto parts do you supply?

A: Our company mainly provides AC Grill vent, Inner pull handle, Cup holder, Coin Storage, Tailgate switch, Car sun visor, Center Console Ashtray and OBD Plug Cover.

Q: What is your terms of payment?

A: T/T 30% as deposit, and 70% before delivery.

Q: How about your delivery time?

A: Generally, it will take 3 to 10 work days after receiving your advance payment. The specific delivery time depends on the items and the quantity of your order.

Q: Can you produce according to the samples?

A: Yes, we have many/ears of development experience and mature technical team including production molds and production technology.

Q: Do you test all your goods before delivery?

A:Yes, we have 100% test before delivery.